User guide

HOLD_A
NO
MEASURE YES
MEASURE
HLD.AO1
50.1
ENTER
HLD.LEV
MEASURE
%
pH
7.02
MEASURE
CALIBRATE
OUT/HOLD
CONFIGURE
SECURITY
DISPLAY
SPT/TUNE
MEASURE
CALIBRATE
OUT/HOLD
CONFIGURE
SECURITY
DISPLAY
SPT/TUNE
NO MEASURE YES
HLD.AO2
50.1
ENTER
HLD.LEV
MEASURE
%
pH
7.02
MEASURE
CALIBRATE
OUT/HOLD
CONFIGURE
SECURITY
DISPLAY
SPT/TUNE
MEASURE
CALIBRATE
OUT/HOLD
CONFIGURE
SECURITY
DISPLAY
SPT/TUNE
HOLD_D
If NO and AO1 is
held, release hold.
If NO and AO2 is
held, release hold.
I-E67-84-1B February,2002 7-4
Figure 7-3. Screen Flow Diagram For Setting
Specific Analog Output Hold Levels.
As seen by Figures 7-3 and 7-4, any single or
combination of analog and relay outputs can be
held to any specified level or state,
respectively. A Hold condition is
commissioned using the YES Key and declined
using the NO Key. The hold level and/or state
is set using the arrow(s) and Enter Keys.
Initiate a Hold Output condition using Figures
7-2, 7-3, and 7-4 as references and the
following procedure:
1) Select the Hold State of Operation using
the SELECT Key.