User guide

I-E67-84-1B February,2002 v
Non-Linear Output State (Advanced)............8-18
Analog Output Two State (Basic/Advanced)............8-21
Relay Output One (Basic/Advanced) ...............8-22
Relay Output Two (Basic/Advanced) ...............8-24
Relay Output Three (Basic/Advanced) ..............8-25
Setpoint Relay Output (Basic/Advanced)..........8-27
Diagnostic Relay Output (Basic/Advanced).........8-28
Cycle Timer Relay Output (Advanced) ...........8-29
Cleaner Relay Output (Advanced) .............8-31
Damping State (Basic/Advanced).................8-33
Diagnostics State (Basic/Advanced)...............8-35
Safe Mode One State (Basic/Advanced)..............8-35
Safe Mode Two State (Basic/Advanced)..............8-36
Spike State (Advanced).....................8-36
CONFIGURATION LOCKOUT ........................8-37
SECTION 9 - SECURITY MODE ........................ 9-1
INTRODUCTION ............................ 9-1
SECURITY STATE OF OPERATION ..................... 9-1
SECTION 10 - SECONDARY DISPLAY MODE ...................10-1
INTRODUCTION ............................10-1
SECONDARY DISPLAY STATE OF OPERATION ................10-1
SECTION 11 - SETPOINT/TUNE MODE .....................11-1
INTRODUCTION ............................11-1
SETPOINT/TUNE STATES OF OPERATION ..................11-1
Setpoint Relay Output (Basic/Advanced).............11-1
Diagnostic Relay Output (Basic/Advanced)............11-3
Cycle Timer Relay Output (Advanced) ..............11-4
Cleaner Relay Output (Advanced) ................11-6
SECTION 12 - UTILITY MODE ........................12-1
INTRODUCTION ............................12-1
FACTORY/USER STATE .........................12-1
User State...........................12-1
Advanced/Basic Programming Mode User State........12-2
Reset Configuration User State..............12-3
Reset Security User State ................12-4
Reset All User State...................12-5
Soft Boot User State...................12-6
SECTION 13 - DIAGNOSTICS ........................13-1
INTRODUCTION ............................13-1
FAULT CODES .............................13-1
Problem Codes .........................13-2
Error Codes ..........................13-4
Calibration Diagnostic Messages ................13-5
Additional Diagnostic Messages.................13-6
SECTION 14 - TROUBLESHOOTING ......................14-1
INTRODUCTION ............................14-1
ANALYZER TROUBLESHOOTING ......................14-1
SENSOR TROUBLESHOOTING .......................14-5
Visual Sensor Inspection....................14-6
Sensor Electronic Test.....................14-7
SECTION 15 - MAINTENANCE ........................15-1