User guide

I-E67-84-1B February,2002 iii
Table of Contents
SECTION 1 - INTRODUCTION ........................ 1-1
OVERVIEW .............................. 1-1
INTENDED USER ............................ 1-2
FEATURES .............................. 1-2
EQUIPMENT APPLICATION ........................ 1-4
INSTRUCTION CONTENT ......................... 1-4
HOW TO USE THIS MANUAL ....................... 1-6
GLOSSARY OF TERMS AND ABBREVIATIONS ................. 1-6
REFERENCE DOCUMENTS ......................... 1-9
NOMENCLATURE ............................ 1-9
SPECIFICATIONS ...........................1-10
ACCESSORIES .............................1-12
SECTION 2 - ANALYZER FUNCTIONALITY AND
OPERATOR INTERFACE CONTROLS ..................... 2-1
INTRODUCTION ............................ 2-1
ANALYZER OVERVIEW .......................... 2-1
USER INTERFACE ........................... 2-2
MODULAR ELECTRONIC ASSEMBLIES .................... 2-2
TEMPERATURE COMPENSATION ...................... 2-3
ANALOG OUTPUTS ........................... 2-3
RELAY OUTPUTS ............................ 2-3
High or Low Set Point ..................... 2-4
High or Low Cycle Timer .................... 2-4
Cleaner ............................ 2-5
DAMPING ............................... 2-6
DIAGNOSTICS ............................. 2-6
Analyzer............................ 2-7
Sensor............................. 2-7
Spike Output.......................... 2-7
SECTION 3 - INSTALLATION ........................ 3-1
INTRODUCTION ............................ 3-1
SPECIAL HANDLING .......................... 3-1
UNPACKING AND INSPECTION ...................... 3-2
LOCATION CONSIDERATIONS ....................... 3-3
HAZARDOUS LOCATIONS ......................... 3-3
RADIO FREQUENCY INTERFERENCE .................... 3-3
MOUNTING .............................. 3-4
Pipe Mounting ......................... 3-4
Hinge Mounting......................... 3-5
Wall Mounting ......................... 3-6
Panel Mounting......................... 3-7
WIRING CONNECTIONS AND CABLING ................... 3-9
Power Wiring..........................3-10
Analog Output Signal Wiring ..................3-11
Relay Output Signal Wiring...................3-11
Advantage Series (TBX5) Sensor Wiring .............3-13
Non-Advantage Series (TB5) Sensor Wiring............3-14
GROUNDING ..............................3-17
OTHER EQUIPMENT INTERFACE ......................3-17
INSTRUMENT ROTATION .........................3-18
SECTION 4 - OPERATING PROCEDURES .................... 4-1
INTRODUCTION ............................ 4-1