User guide

CUT OUT
REAR VIEW
+0.05/-0.03
+1.3/-0.8
+1.3/-0.8
+0.05/-0.03
I-E67-84-1B February,2002 3-8
2) Cut a 135.4 mm x 135.4 mm hole with
diagonal corners through the panel as shown in
Figure 3-5.
3) Install the panel gasket onto the
instrument.
4) Remove Rear Cover if necessary, and insert
the instrument through the panel cut-out.
5) Attach the panel mounting bracket assembly
to all four corners of the analyzer.
6) Tighten the adjustment screws on the panel
mounting brackets until the analyzer seats
against the panel. Note, do not over-tighten
the adjustment screws or damage to the
brackets and panel may result.
Figure 3-5. Panel Mount Installation Diagram