User guide

I-E67-84-1B February,2002 3-2
5. Avoid partial connection of
semiconductors. Semiconductors can be damaged
by floating leads. Always install electronic
assemblies with power removed. Do not cut
leads or lift circuit paths when
troubleshooting.
6. Ground all test equipment.
7. Avoid static charges during maintenance.
Make sure the circuit board is thoroughly
clean around its leads but do not rub or clean
with an insulating cloth.
NOTE: An antistatic field service kit, ABB part number
1948385_1, is available for personnel working on
devices containing static sensitive components. The
kit contains a static dissipative work surface (mat),
a ground cord assembly, wrist bands, and alligator
clip.
UNPACKING AND INSPECTION
Examine the equipment upon receipt for
possible damage in transit. File a damage
claim with the responsible transportation
company, if necessary. Notify the nearest ABB
sales office.
Carefully inspect the packing material before
discarding it to make certain that all
mounting equipment and any special
instructions or paperwork have been removed.
Careful handling and installation will insure
satisfactory performance of the unit.
Use the original packing material and
container for storage. Select a storage
environment free of corrosive vapors and
extreme temperature and humidity. Storage
temperature must not exceed -40 degrees to +70
degrees Celsius (-40 degrees to +158 degrees
Fahrenheit).
Remove the protective film from the analyzer
lens after the analyzer has been placed in its
final installed location.