User guide

I-E67-84-1B February,2002 3-1
SECTION 3 - INSTALLATION
INTRODUCTION
This section of the manual will aide the user
in all levels of the installation process.
The intention is to provide simple procedures
for placing the TB84PH Advantage Series
analyzer into service.
SPECIAL HANDLING
Besides the normal precautions for storage and
handling of electronic equipment, the analyzer
has special static sensitive device (SSD)
handling requirements. This equipment
contains semiconductors subject to damage by
discharge of static electricity; therefore,
avoid direct contact with terminal block
conductors and electronic components on the
circuit board.
To minimize the chances of damage by static
electricity, follow these techniques during
wiring, service, troubleshooting, and repair.
1. Remove assemblies containing
semiconductors from their protective
containers only:
a. When at a designated static-free work
station.
b. After firm contact with an antistatic
mat and/or gripped by a grounded individual.
2. Personnel handling assemblies with
semiconductors must be neutralized to a
static-free work station by a grounding wrist
strap connected to the station or to a good
ground point at the field site.
3. Do not allow clothing to make contact
with semiconductors. Most clothing generates
static electricity.
4. Do not touch connectors, circuit traces,
and components.