User guide

I-E67-84-1B February,2002 12-4
To reset the configuration to factory
defaults, use the following procedure:
1) Access the User Mode by pressing the
hidden button located directly above the
NT in the ADVANTAGE text on the keypad.
The text USER will appear in the
secondary display once the hidden button
has been pressed.
2) Press the SELECT Key to access the User
Mode. The text MODE will appear in the
secondary display.
3) Press the NEXT Key to display RST.CON
(i.e., Reset Configuration) text.
4) Press the SELECT Key to reset the
configuration.
5) Enter the security password (if the
Configure Mode has been secured) using
the Key to increment the blinking
digit and the Key to move to the next
digit, and press the ENTER Key to enter
the password.
6) Confirm the reset operation when the text
RESET? is displayed by pressing the YES
Key, or abort the reset operation by
pressing the NO Key.
Reset Security User State
The Reset Security User State returns the
security to factory default settings. The
factory default is security OFF for all
applicable modes and states (i.e., Calibrate,
Output/Hold, Modify Configure, and
Setpoint/Tune).