User guide

DIAGS1
ALL
MEASURE
INSTR.
MEASURE
NEXT
ENTER
ENTER
CONFIG
EXIT
pH
7.02
pH
7.02
MEASURE
CALIBRATE
OUT/HOLD
CONFIGURE
SECURITY
DISPLAY
SPT/TUNE
MEASURE
CALIBRATE
OUT/HOLD
CONFIGURE
SECURITY
DISPLAY
SPT/TUNE
SENSOR
MEASURE
NEXT
ENTER
pH
7.02
MEASURE
CALIBRATE
OUT/HOLD
CONFIGURE
SECURITY
DISPLAY
SPT/TUNE
NEXT
Last selected
RELAY1
RETURN
NEXT
I-E67-84-1B February,2002 11-4
Set the trigger for the Diagnostic Relay
Output using Figure 8-12 as reference and the
following procedure:
1) Set the Diagnostic trigger using the NEXT
Key to toggle between ALL, SENSOR, and
INSTR. (i.e., Instrument), and press the
ENTER Key to enter the new trigger.
Figure 8-12. Screen Flow Diagram For Setting
the Diagnostic Relay Output Configure State of
Operation.
Cycle Timer Relay Output (Advanced)
A Cycle Timer can only be sourced to the
Process Variable and can energize the relay
for either a High or Low setpoint condition.