User guide

I-E67-84-1B February,2002 10-1
SECTION 10 - SECONDARY DISPLAY MODE
INTRODUCTION
The TB84PH Advantage Series analyzer has two
display regions. In the Measure Mode of
Operation, the primary display region shows
the measured process variable, and the
secondary display region can show a multitude
of process, sensor, or analyzer information.
This information can be viewed or set as the
displayed value when in the Measure Mode of
Operation.
SECONDARY DISPLAY STATE OF OPERATION
The Secondary Display Mode of Operation
contains seven states of operation that
provide information on the process
temperature, output current values, sensor
output, software revision, and spike status.
As seen in Figure 10-1, each Secondary Display
State can be sequentially viewed by using the
NEXT Smart Key. To have any given Secondary
Display State be continually shown in the
Measure Mode, press the ENTER Smart Key while
the desired state is displayed. The TB84PH
Advantage Series analyzer will proceed to the
Measure Mode and display the entered Secondary
Display State in the secondary display region.