User guide

I-E67-84-1B February,2002 9-4
Change the password or security state using
the following procedure:
1) Select the SECUR Mode of Operation using
the SELECT Key.
2) Enter the password for all secured modes
and states using the Key to increment
the blinking digit and the Key to move
to the next digit, and press the ENTER
Key to submit the password.
3) Leave the security state unchanged for
CALIBR (i.e., Calibrate) Mode by using
the ENTER Key Set, or if needed, change
the security state for CALIBR (i.e.,
Calibrate) using the Key. Press the
ENTER Key to enter the new value.
4) Leave the security state unchanged for
OUTPUT (i.e., Output/Hold) Mode by using
the ENTER Key Set, or if needed, change
the security state for OUTPUT using the
Key. Press the ENTER Key to enter the
new value.
5) Leave the security state unchanged for
CONFIG (i.e., Modify Configure) State by
using the ENTER Key Set, or if needed,
change the security state for CONFIG
(i.e., Modify Configure) using the
Key. Press the ENTER Key to enter the
new value.
6) Leave the security state unchanged for
SPT.TUN (i.e., Setpoint/Tune) Mode by
using the ENTER Key Set, or if needed,
change the security state for SPT.TUN
(i.e., Setpoint/Tune) using the Key.
Press the ENTER Key to enter the new
value.
7) Change the password for all secured modes
and states using the Key to increment
the blinking digit and the Key to move
to the next digit, and press the ENTER
Key to enter the password.