User guide

I-E67-84-1B February,2002 9-3
6) Define the password for all secured modes
and states using the Key to increment
the blinking digit and the Key to move
to the next digit, and press the ENTER
Key to enter the password.
Note: The password must be defined as three
digits and verified to enable security on the
modes/states entered in steps 2 through 4. If
security is not ON for any of the modes/states,
the password state will be bypassed.
6) Verify the password using the Key to
increment the blinking digit and the
Key to move to the next digit, and press
the ENTER Key to enter the password.
Remove all security using the following
procedure:
1) Select the SECUR Mode of Operation using
the SELECT Key.
2) Enter the password for all secured modes
and states using the Key to increment
the blinking digit and the Key to move
to the next digit, and press the ENTER
Key to submit the password.
3) Set the security for the CALIBR (i.e.,
Calibrate) Mode by pressing the Key to
toggle the display to OFF, and press the
ENTER Key to enter the value.
4) Set the security for the OUTPUT (i.e.,
Output/Hold) Mode by pressing the Key
to toggle the display to OFF, and press
the ENTER Key to enter the value.
5) Set the security for the CONFIG (i.e.,
Modify Configure) State by pressing the
Key to toggle the display to OFF, and
press the ENTER Key to enter the value.
6) Set the security for the SPT.TUN (i.e.,
Setpoint/Tune) Mode by pressing the
Key to toggle the display to OFF, and
press the ENTER Key to enter the value.