User guide

DAMPNG
0.0
ENTER
SECS
MEASURE
DAMPNG
RETURN
CONFIG
EXIT
MEASURE
CALIBRATE
OUT/HOLD
CONFIGURE
SECURITY
DISPLAY
SPT/TUNE
0.0
ENTER
DSP.SEC
MEASURE
MEASURE
CALIBRATE
OUT/HOLD
CONFIGURE
SECURITY
DISPLAY
SPT/TUNE
0.0
ENTER
A01.SEC
MEASURE
MEASURE
CALIBRATE
OUT/HOLD
CONFIGURE
SECURITY
DISPLAY
SPT/TUNE
0.0
ENTER
AO2.SEC
MEASURE
MEASURE
CALIBRATE
OUT/HOLD
CONFIGURE
SECURITY
DISPLAY
SPT/TUNE
ADVANCED Configuration Only.
BASIC
Configuration
Only.
I-E67-84-1B February,2002 8-34
2) For Basic configurations, set the new
damping value using the Key to
increment the blinking digit and the
Key to move to the next digit, and press
the ENTER Key to enter the new value.
3) For Advanced configurations, set the new
damping value for the Displayed Process
Variable (i.e., DSP.SEC) using the Key
to increment the blinking digit and the
Key to move to the next digit, and
press the ENTER Key to enter the new
value.
Figure 8-15. Screen Flow Diagram For Damping
Configure State of Operation.
4) For Advanced configurations, set the new
damping value for Analog Output One
(i.e., AO1.SEC) using the Key to
increment the blinking digit and the
Key to move to the next digit, and press
the ENTER Key to enter the new value.
5) For Advanced configurations, set the new
damping value for Analog Output Two