User guide

CLNR1
1.0
CYC.HRS
MEASURE
1.0
ON.MIN
MEASURE
10.0
RCV.MIN
MEASURE
CONFIG
EXIT
ENTER
ENTER
ENTER
RELAY1
RETURN
MEASURE
CALIBRATE
OUT/HOLD
CONFIGURE
SECURITY
DISPLAY
SPT/TUNE
MEASURE
CALIBRATE
OUT/HOLD
CONFIGURE
SECURITY
DISPLAY
SPT/TUNE
MEASURE
CALIBRATE
OUT/HOLD
CONFIGURE
SECURITY
DISPLAY
SPT/TUNE
NO MEASURE YES
HLD.AO
pH
7.02
MEASURE
CALIBRATE
OUT/HOLD
CONFIGURE
SECURITY
DISPLAY
SPT/TUNE
*
* 99.9 is the maximum allowable time limit.
*
*
HLD.RO
MEASURE
MEASURE
CALIBRATE
OUT/HOLD
CONFIGURE
SECURITY
DISPLAY
SPT/TUNE
DSBL.RO
MEASURE
MEASURE
CALIBRATE
OUT/HOLD
CONFIGURE
SECURITY
DISPLAY
SPT/TUNE
NOYES
NOYES
7.02
pH
7.02
pH
I-E67-84-1B February,2002 8-33
Figure 8-14. Screen Flow Diagram For Setting
the Cleaner Relay Output Configure State of
Operation.
Damping State (Basic/Advanced)
The Damping State applies a lag function on
the configured signals and reduces
fluctuations caused by erratic process
conditions. The damping value can be set from
0.0 to 99.9 seconds and represents the time
required to reach 63.2% of a step change in
the process variable.
For the Basic Programming Mode, the damping
value can only be applied to the process
variable input signal. The Advanced
Programming Mode allows for separate damping
of the Display Process Variable, Analog Output
One, and Analog Output Two.
Set the Damping State using Figure 8-15 as a
reference and the following procedure:
1) Select the DAMPNG State using the SELECT
Key.