User guide

SETPT1
10.0
ENTER
HI SPT
MEASURE
CONFIG
EXIT
RELAY1
RETURN
ENTER
DBAND
MEASURE
0.0
ENTER
DLY.MIN
MEASURE
MEASURE
CALIBRATE
OUT/HOLD
CONFIGURE
SECURITY
DISPLAY
SPT/TUNE
MEASURE
CALIBRATE
OUT/HOLD
CONFIGURE
SECURITY
DISPLAY
SPT/TUNE
MEASURE
CALIBRATE
OUT/HOLD
CONFIGURE
SECURITY
DISPLAY
SPT/TUNE
Display "HI" or "LO",
as configured.
pH
0.50
pH
*
* 99.9 minutes is the
maximum allowable time
limit.
Display units and PV as configured.
I-E67-84-1B February,2002 8-28
3) Set the Time Delay in minutes (i.e.,
DLY.MIN) using the Key to increment
the blinking digit and the Key to move
to the next digit, and press the ENTER
Key to enter the new value.
Figure 8-11. Screen Flow Diagram For Setting
the Setpoint Relay Output Configure State of
Operation.
Diagnostic Relay Output (Basic/Advanced)
A Diagnostic Relay Output simply energizes
when a diagnostic condition has be detected.
The relay can be configured to trigger on a
sensor, instrument, or all diagnostic
conditions.