User guide

I-E67-84-1B February,2002 8-25
HI.TMP.C, LO.TMP.C, HI.TMP.F, and
LO.TMP.F for Basic Configurations or
HI.PV, LO.PV, HI.TMP.C, LO.TMP.C,
HI.TMP.F, LO.TMP.F, DIAGS, HI.PV.CT,
LO.PV.CT, or CLNR, and press the ENTER
Key to enter the new function.
Since the parameters for each type of relay
function are the same, this information will
be given after reviewing the applicable
functions for each relay output.
Relay Output Three (Basic/Advanced)
The Relay Output Three State sets the output
function and parameters for Relay Output
Three. The output function is dependent on
the programming mode. For Basic
configurations, Relay Three output functions
are limited to Setpoint control of the Process
Variable and Temperature and Diagnostic
notification. For Advanced configurations,
the output functions are not limited and can
be configured as a Setpoint sourced to the
Process Variable or Temperature, Cycle Timer,
Diagnostic, or Cleaner.
Set the output function of Relay Output Three
State using Figure 8-10 as reference and the
following procedure:
1) Select the RELAY3 State using the SELECT
Key.