User guide

AO2.OUT
ENTER
MEASURE
ENTER
MEASURE
7.02
7.02
MEASURE
CALIBRATE
OUT/HOLD
CONFIGURE
SECURITY
DISPLAY
SPT/TUNE
MEASURE
CALIBRATE
OUT/HOLD
CONFIGURE
SECURITY
DISPLAY
SPT/TUNE
AO2.OUT
RETURN
PV
MEASURE
TEMP F
MEASURE
ENTER
ENTER
pH
7.02
pH
7.02
MEASURE
CALIBRATE
OUT/HOLD
CONFIGURE
SECURITY
DISPLAY
SPT/TUNE
MEASURE
CALIBRATE
OUT/HOLD
CONFIGURE
SECURITY
DISPLAY
SPT/TUNE
TEMP C
MEASURE
NEXTENTER
pH
7.02
MEASURE
CALIBRATE
OUT/HOLD
CONFIGURE
SECURITY
DISPLAY
SPT/TUNE
NEXT
Last Selected
o
o
0-20MA
4-20MA
CONFIG
EXIT
NEXT
ENTER
MEASURE
100
MEASURE
CALIBRATE
OUT/HOLD
CONFIGURE
SECURITY
DISPLAY
SPT/TUNE
20MA.PT
ENTER
MEASURE
25
MEASURE
CALIBRATE
OUT/HOLD
CONFIGURE
SECURITY
DISPLAY
SPT/TUNE
4MA.PT
NEXT
NEXT
Display either 0mA or 4mA
according to selected range.
C
O
C
O
Last Selected
Last Selected
pH
pH
Bypass for ION.CON Configurations
I-E67-84-1B February,2002 8-22
Figure 8-7. Screen Flow Diagram For Analog
Output Two Configure State of Operation.
Relay Output One (Basic/Advanced)
The Relay Output One State sets the output
function and related parameters for Relay
Output One. The output function is dependent
on the programming mode. For Basic
configurations, Relay One output functions are
limited to Setpoint control of the Process
Variable. For Advanced configurations, the
output functions are not limited and can be
configured as a Setpoint sourced to the
Process Variable or Temperature, Cycle Timer,
Diagnostic, or Cleaner.
Set the output function of Relay Output One
State using Figure 8-8 as reference and the