User guide

I-E67-84-1B February,2002 8-19
1) Select the AO2.OUT State using the SELECT
Key.
2) Set the output span using the NEXT Key to
toggle between 4-20MA and 0-20MA, and
press the ENTER Key to enter the new
span.
3) Set the process variable value for the
zero or four milliampere point using the
Key to increment the blinking digit and
the Key to move to the next digit, and
press the ENTER Key to enter the new
value.
4) Set the process variable value for the 20
milliampere point using the Key to
increment the blinking digit and the
Key to move to the next digit, and press
the ENTER Key to enter the new value.
4) Select the NON.LIN Output State by using
the NEXT Key to change the programming
state from LINEAR to NON.LIN and using
the SELECT Key to accept the NON.LIN
Output State.
5) Set the input percentage for the first
break point (X-1) using the Key to
increment the blinking digit and the
Key to move to the next digit, and press
the ENTER Key to enter the new value.