User manual

Klinkmann Automation SPA Bus Server 6
SPA Server Ver 1.x User Manual Rev 2.3 120XXM23
Runtime Package), copied to SPA Server folder only if “HASP
Device driver” is selected during the installation in “Custom
Setup” dialog.
LICENSE.RTF
Klinkmann Automation software license file.
KLSERVER.DLL
Dynamic Link Library necessary for “OPC & DDE” version of
the Server.
WWDLG32.DLL
Dynamic Link Library necessary only for “OPC & DDE” version of
the Server.
In case the “HASP Device driver” is selected during the installation in “Custom Setup”
dialog, the Sentinel LDK Run-time Environment (HASP HL Runtime Package) is installed
during the SPA Server installation (and will be uninstalled during the SPA Bus Server
uninstallation). The presence of Sentinel LDK Run-time Environment can be checked
after the SPA Bus Server installation by looking-up in Control Panel / Administrative Tools
Services – the Service “Sentinel Local License Manager” must be started.
Notes:
1. The SPA Bus Server “Suite Link & DDE” version is developed with Wonderware I/O
Server Toolkit (ver 7,2,1,6) and needs the Wonderware FS 2000 Common
Components to be installed on computer where the SPA Server is running. If using
Wonderware InTouch 8.0 or newer, install the FS 2000 Common Components before
installing InTouch (see also Wonderware Tech Notes 404 and 313). The Wonderware
FS2000 Common Components are installed automatically when any of Wonderware
product (e.g. InTouch or some Wonderware I/O server) is installed.
2. If SPA Bus Server “Suite Link & DDE” version will run on PC where Wonderware
FS2000 Common Components are not installed then a special I/O Server Infrastructure
installation package can be obtained from Klinkmann Automation (see Installing the
I/O Server Infrastructure section below). This I/O Server Infrastructure installation
package contains the minimum set of software needed to run the SPA Bus Server and
these infrastructure files must be install prior to executing the SPA Bus Server.The I/O
Server Infrastructure does not support using SPA Bus Server as a Windows Service
and remote access to SPA Bus Server (when DDE/SuiteLink Client is not located on
same computer as SPA Bus Server).
To uninstall the SPA Bus Server, start Control Panel, select “Uninstall a program”
(“Add/Remove Programs” on XP/2003) and select the “ABB SPA Bus SuiteLink and DDE
Server” or “ABB SPA Bus OPC and DDE Server” from the list of available software
products. Click on “Uninstall” (“Add/Remove…” on XP/2003) and proceed as directed by
the Uninstall Wizard.