Product specifications

SPlus Operations P13 Connectivity Guide PROCONTROL P13 OPC SERVER
2VAA001153C 69
Figure 3-54: VPC Mode “Mixed Mode I” Configuration
3.10.2.2 Configure Analog Control (XC13) Part
 Select number of ID bits in dialog General->VPC Modes.
 Configure signal ID for ID bits with VPCID instruction in the pve-file
(see 3.3.3.4.1 Parameter Set VPCID for ID-Signals Definition).
 Configure existing command channels per bus. Set addresses for XC11 and XC12 to zero.
 Configure bit for acknowledge if not default.
3.10.2.3 Configure Binary Control Part
All configurations concerning the binary control part are done in the pve-file.
3.10.2.4 
              

The VPC Submode can be selected via the following instruction:
VPCDEF, SUBMODE, RMPI
The SWV command signals have to be configured.
3.10.2.5 Example pve-configuration
The following table shows a sample pve configuration for Mixed Mode I.
Table 3-48: Sample PVE-Configuration for Mixed Mode I
#Command signals for
binary control
Type
ACKN
ON/
SEL1
OFF/
SEL2
STOP/
SEL3
SEL4
REL
(ind.)
#Global Signals
Bus0
Bus1
VPCDEF1
ACKN
10CKA21
GK001_
ACKN
*