User's Manual
Table Of Contents
- FCC Notice to Users and Operators
- Introduction
- Installation Guidelines
- Operating Your Wireless Router
- Safety Information for the Wireless Router
- Service Instructions
12
Installation Guidelines
Figure 7 SmartPoint and RoutePoint Wireless Router Antenna Connectors
Connecting Power and LAN
The LAN port on your SmartPoint or RoutePoint is compatible with IEEE 802.3 af-compliant power
sourcing devices, as shown in Figure 8. If you are using Power Over Ethernet you will not need to
connect a separate power supply.
Note When the SmartPoint or RoutePoint wireless router is installed in a plenum or air-handling
space, the cables employed should be suitable under NEC article 800-50 and NFPA 262 and
marked accordingly, for use in plenums and air-handling spaces with regard to smoke
propagation, such as CL2-P, CL3-P, MPP or CMP.
Figure 8 Power Over Ethernet Option
Note If you use the Power Over Ethernet option, make sure that the power sourcing device is IEEE
802.3 af-compliant.
Follow these steps to connect a SmartPoint or RoutePoint wireless router to your network:
Step 1 Attach a category 5 twisted pair patch cable to the Ethernet port labeled LAN on the
SmartPoint or RoutePoint wireless router as shown in Figure 9.
fhp_007
Apply 2 drops of Loctite here
fhp_012
LAN port
Power injector
(not supplied by FHP)