Technical data

Chapter 2 – Installation
2-8 RS485 and RS232 Adapter Installation and Start-up Guide
Installation to RS232 Bus
1 Make sure power is not connected to the ACS 160.
2 Confirm that the operation mode is RS232 (jumper S3).
3 Mount the adapter on the side of the ACS 160.
4 Connect the control panel to the drive.*
5 Connect power to ACS 160. *
6 Set up communication: Station number, communication speed of the drive
and parity. Refer to Chapter 3 – Programming. *
7 Set up other drive parameters as needed. Refer to ACS 160 User’s Manual
and Chapter 3 of this manual. *
8 Disconnect power from the ACS 160.
9 Disconnect control panel.
10 Connect drive connection cable of the adapter. Plug in the RS232 cable
(X4).
* These steps can be ignored when using DriveWindow Light PC tool, or when
the default communication settings are used.