Technical data

Chapter 2 – Installation
2-2 RS485 and RS232 Adapter Installation and Start-up Guide
Mounting
The CFB-RS can be mounted onto the ACS 160 drive with two screws as
shown in the ACS 160 User's Manual. This also provides the earthing of the
module housing.
The CFB-RS uses the control panel connector of the drive. The CFB-RS is
powered through this connector.
The CFB-RS provides two cable entries for the incoming and outgoing bus
cables. The cables are connected to a detachable terminal header.
If only one bus cable is connected, the unused cable entry should be plugged.
Remove the front cover to access the configuration switches and jumpers.