Installation Manual

1
The RPMP-11 Control Panel Mounting Platform kit (+J410, codes: 64736175, 68443156, 68443164) includes the
accessories for installing the CDP312R control panel onto a cabinet door. The RPMP-13 Control Panel Mounting Platform
kit (code: 64736141) includes also the CDP312R control panel.
The mounting platform is snap-mounted to a 1.5...2.5 mm thick door plate (no screws are required). The control panel is
attached to the mounting platform by pushing it into the recess. The degree of protection of the control panel is IP54 when
attached.
68412102.asm
1
4
8
6
X3
X2
X5
3
Cutting in the cabinet door
7
For connection of
NLMD monitoring
display (optional,
supported by System
Application program
only)
1. CDP312R control
panel (RPMP-13
only)
2. Extension connector
(RPMP-13 only)
3. Control panel
mounting platform
4. EMC shield and
locking plate
5. Panel interface
board ADPI
6. Screws for fastening
the board onto the
platform
7. Grounding wire
2
5
8. Shielded flat-oval cable
3 m (118 in.)
To RMIOTo ADPI
Used with:
• ACS800-04 modules of frame sizes R2 to
R4 with swing-out panel support
• ACS800-04 modules of frame sizes R5
and R6
• ACS800 multidrive modules of frame
sizes R5i.
Plug the cable in the socket on the bottom
of the control panel recess of the module.
Used with:
• ACS800-04 modules of frame sizes R2 to
R4 without swing-out panel support
• ACS800-04/04M/U4 modules of frame
sizes R7 and R8
• ACS800 multidrive modules of frame sizes
R2i, R3i, R4i, R7i and R8i.
Connect the cable to RMIO board connector
X39 in the RDCU unit.
3 m (118 in.)
To R M I OTo ADPI
ACS800
Installation Guide
RPMP-11/13 Control Panel Mounting Platform Kit
+J410