Hardware manual

Starting up fieldbus communication and programming the ABB PLC
59
Start-up flowchart
The steps of the start-up procedure are presented below. Perform the steps from first
to last.
No. Task Description / See instruction
ELECTRICAL INSTALLATION In this section, you wire the equipment used in this programming
example.
1 Connect the PC RJ-45 cable to
drive terminal X7.
ACS850-04 Drive Modules (1.1 to 45 kW) Hardware Manual
(3AUA0000045496 [English])
Page 61
2 Connect the PLC fieldbus master
(CM572-DP) to the fieldbus
adapter module (FPBA-01) of the
drive.
Installation of the TA510-CASE, page 61
3 Connect the PC serial port (COM)
to the PLC programming port.
OR:
Connect the PC Ethernet port to
the PLC Ethernet port with an RJ-
45 Ethernet cable.
OR:
Connect the PLC serial port to the
PC USB port with a TK503
programming cable
Installation of the TA510-CASE, page 61
TK503 programming cable order code: 1TN968901R1100
SOFTWARE INSTALLATION In this section, you install the programming tools.
1 Install the DriveStudio PC tool if
not yet installed.
Installing the DriveStudio PC tool, page 62
2 Install the AC500 Control Builder
PS501 software.
Installing the AC500 Control Builder PS501 software, page 62
3 Install additional GSD files. Installing additional GSD files, page 63
PROGRAMMING In this section, you set up the communication between the drive
and the PLC and make the PLC program that controls the drive
through fieldbus.
– – – O N E - D R I V E S Y S T E M – – –
1 Set the drive control program
parameters.
In this section you set the drive parameters needed for
communication with the FPBA-01 fieldbus adapter module.
Setting the drive control program parameters, page 65