Technical data

2CMC480022C0003| Electricity meters 21

ODIN

Description

The ODIN is a basic meter for installation in three phase

4-wire networks. The meter is mounted on a DIN rail and

is suitable for installation in distribution boards and small

encloses such as consumer units.

The meter is available

in two versions, one direct connected and one transformer

connected.

Both these versions measures active energy.

The product is configuration free (except for the setting of

transformer ratio on OD 4110) which makes it very easy to

deal with in all applications.

General features

ODIN is a meter that is very easy to handle. It is easy to read the

large LCD display with 6 mm high digits and symbols for load

indication, voltages etc. The meter has a LED on the front that

ﬂashes proportionally to the measured energy. The energy con-

sumption of the meter is low, less than 0.9 VA per phase.

Communication

Data from ODIN is collected via pulse output or serial com-

munication. The pulse output generates pulses proportionally

to the measured energy. ODIN comes with an infrared port for

communication with an external Serial Communication Adapter

(SCA). There are SCAs for M-Bus, RS-232, Ethernet, GSM/GPRS

and KNX (See Communication adapters, page 42).

Configuration

There is no conﬁguration for the direct connected version of ODIN.

For the transformer connected version, the only conﬁguration

needed is the setting of the transformer ratio. This is easily done

via one push button where the appropriate setting is selected.

This conﬁguration button is sealed when the meter is installed in

a sealable DIN rail enclosure or when a cover (see accessories,

page 21) is mounted.

Installation

ODIN features an installation diagram on the front of the meter.

This makes it very easy to install. All terminals are clearly marked.

A load indicator and voltage indication is displayed on the LCD

for easy veriﬁcation of the installation. ODIN is also prepared for

busbar installation.

Approval

ODIN is type approved according to IEC and it is both type

approved and veriﬁed according to MID. MID is the Measuring

Instruments Directive 2004/22/EC from the European Commis-

sion. MID type approval and veriﬁcation is mandatory for meters

in billing applications within EU and EEA.