Installation Manual

Electrical installation

1. The Ethernet cable is inserted. Refer to section 7.4.1.

7.4.2

Connect the Ethernet cable

Preliminary requirements

If your EVSE has two Ethernet connections, it is possible to connect multiple EVSEs

in a chain. Only the first EVSE is connected to the PC, router or gateway. Only the

Ethernet connection is shared, there is no communication between the EVSEs.

Procedure

Put the RJ45 plug (A) of the Ethernet

cable in the primary Ethernet RJ45

socket (B).

Connect the Ethernet cable either to a

PC, router, or gateway or to the

previous EVSE in a chain (C).

If you connect EVSEs in a chain, put

the RJ45 plug of Ethernet cable to the

next EVSE (D) in the secondary

Ethernet RJ45 socket (E).

7.4.3

Insert the wires for the smart meter communication

Remove the grommet (A) from the

EVSE.

Install the conduit.

If necessary, strip the cable to the

correct length. Refer to section 10.12.3.

Put the cable (B) through the inlet

hole.