Installation Manual

Electrical installation
33
7.2.3 Insert the AC input cable
Preliminary requirements
• Screwdriver
• AC input cable
Procedure
1. Remove the grommet (A) from
the EVSE.
2. Install the conduit.
3. Strip the wires. For the
specification, refer to section
10.13.
4. Put the AC input cable (B) through
the inlet hole.
All Specifications are Per Charging Station or Port
Max. Output
(Charging)
Current
Typical Circuit
Breaker (CB)
3
Typical Wire Specs
Typical
Conduit
Size
Notes / Assumptions
12A
15A
Two #12AWG Wires (Line)
One #12AWG Wire (Ground)
1"
≤150FT. One-Way Distance.
≤3% Voltage Drop
16A
20A
Two #10AWG Wires (Line)
One #12AWG Wire (Ground)
1"
≤150FT. One-Way Distance.
≤3% Voltage Drop
24A
30A
Two #8AWG Wires (Line)
One #10AWG Wire (Ground)
1"
≤150FT. One-Way Distance.
≤3% Voltage Drop
32A
40A
Two #8AWG Wires (Line)
One #10AWG Wire (Ground)
1"
≤150FT. One-Way Distance.
≤3% Voltage Drop
40A
50A
Two #6AWG Wires (Line)
One #8AWG Wire (Ground)
1"
≤150FT. One-Way Distance.
≤3% Voltage Drop
64A
80A
Two #4AWG Wires (Line)
One #8AWG Wire (Ground)
1"
≤150FT. One-Way Distance.
≤3% Voltage Drop
72A
90A
Two #3AWG Wires (Line)
One #8AWG Wire (Ground)
1"
≤150FT. One-Way Distance.
≤3% Voltage Drop
80A
100A
Two #2AWG Wires (Line)
One #8AWG Wire (Ground)
1"
≤150FT. One-Way Distance.
≤3% Voltage Drop