Installation Manual

Electrical installation
32
7.2.2 Install the lugs or cold-pressed terminal for L1,L2
(1) Lugs
Preliminary requirements
• Torque Screwdriver
• AC input cable (1 phase)
• Lugs. Refer to section 10.6.
•
Procedure
1. Loosen the screws(A)
2. Strip the wires. For the
specification, refer to section
10.12.1..
3. Insert the wire in the side 1 of
lugs.
4. Tighten the screws(A) to the correct
torque. For the specification,
refer to section 10.14
(2) Cold-pressed terminal
Preliminary requirements
• Crimping Tool(2AWG)
• AC input cable (1 phase)
• Cold-pressed terminal for
L1,L2. Refer to section 10.6.
•
Procedure
1. Strip the wires. For the
specification, refer to section
10.12.1.
2. Insert the cable into the cable
lug or connector to its full
insertion length. Crimp the
cable lug or connector with the
correct jaws.
3. Finished.