Installation Manual

Mechanical installation

6.1

General mechanical installation procedure

Note: The mounting screws and plugs that are included in the

delivery are serviceable for a brick wall. If you want to mount

the EVSE on a different type of wall, contact your local

representative of the manufacturer (ABB EV Infrastructure).

1. Prepare the holes for the mounting screws. Refer to section 6.2.

2. Move the socket. Refer to section 6.3.

3. Install the EVSE on the site. Refer to section 6.4.

6.2

Prepare the holes for the mounting screws

Preliminary requirements

•

Spirit level

•

Drill

•

nstallation template.

Refer to section 10.6.

•

Plugs for the mounting

holes. Refer to section

10.6

Procedure

1. Hold the installation template

(A) against the wall.

2. Make sure that the installation is

level. Use the spirit level.

3. Mark the location for the

mounting holes (B).

4. Drill the mounting holes (B).

Note: For the diameter of

the holes, refer to the

plugs for the upper and

lower mounting holes.

5. Insert the plugs for the

mounting holes (C) in the

mounting holes.