SDS

Page | 3
Eye Contact: Immediately flush eyes with water for at least 15 minutes and check for and remove
contacts. Hold eyelids apart to rinse entire eye surface. Seek medical attention if irritation persists.
Continue washing if medical attention is not immediately available.
Skin Contact: Wipe off excess immediately and wash affected area with soap and water for at least 15
minutes. Remove contaminated clothing or shoes and seek medical attention if irritation persists.
Continue washing if irritation persists.
Inhalation: If inhaled, remove victim to fresh air and consult medical personnel immediately. If person
is not breathing or breathing is irregular, provide oxygen with the aid of trained personnel only. If
unconscious, place in recovery position and seek medical attention immediately.
Ingestion: Wash out mouth with small amounts of water and remove person to fresh air. Do not induce
vomiting unless directed to do so by medical personnel. Seek medical attention immediately. If
unconscious, place in recovery position. Never give anything by mouth to an unconscious person.
Primary Routes of Entry: Eye and skin contact, breathing vapors.
SECTION 5: Fire-Fighting Measures
Flash Point: >200 ºF (>93.3 °C) Flammable Limits (STP In Air)
Method Used: ASTM D3278-96 LFL/UFL: Not Determined
Suitable Extinguishing Media: Water fog, alcohol-resistant foam, CO
2
and dry chemicals
Unsuitable Extinguishing Media: None known
Specific Hazards and Procedures: Remove all persons from the vicinity. Burning material may
generate large amounts of vapor and produce noxious and toxic fumes. Combustion and/or
decomposition products include carbon oxides.
Specific Fire Fighting Equipment: Firefighters should wear a self-contained breathing apparatus and
personal protective clothing.
Hazardous Combustion Products: Burning material may generate large amounts of vapor and
produce noxious and toxic fumes. Combustion and/or decomposition products include carbon
monoxide, carbon dioxide and halogenated compounds.
SECTION 6: Accidental Release Measures
Personal Protective Measures: Provide adequate ventilation and keep all unnecessary and unprotected
personnel from entering the area. Do not touch or walk through spilled material. Avoid breathing vapor
or mist. Wear an appropriate respirator when ventilation is inadequate. Use appropriate safety equipment
before taking any action.
Methods and Material for Containment and Cleaning Up: Stop flow of material with sand or other
inert material and move container from spill area. Absorb spill with an inert material, scrape up and
place in appropriate waste disposal container. Remove residual resin with non-flammable solvent and
flush contaminated area with hot water. Do not dump waste into any sewers, on the ground or into any