Specifications

Publication 1747-UM011G-EN-P - June 2008
Maintaining Your Control System 139
Remove Damaged Retainer Clips
If necessary, pry off the broken retainer clip from the bottom with a
screwdriver. Do not twist it off. You can damage the module.
Install New Retainer Clips
Insert one of the pins of the retainer clip into the hole in the I/O
module and then snap the other end in place.
Replace a Fuse on the
Power Supply
Follow this procedure to replace a fuse on the power supply (only for
the 1746-P1, 1746-P2, and 1746-P3 power supply).
1. Remove power from the SLC 500 power supply.
2. Open the door on the power supply and use a fuse puller to
remove the fuse.
Retainer Clip
ATTENTION
Use only replacement fuses of the type and rating
specified for the unit. Improper fuse selection can result
in equipment damage.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com