Owner manual

Troubleshooting
15
Possible Causes Solution
There is no power Check to ensure the power outlet or battery source is good. Check
the power adapter to ensure a proper connection with the wall
outlet as well as the projector.
The projector is in the shut-down cooling cycle Wait until the projector has fully cooled to restart
Possible Causes Solution
The video source is not properly connected Check the video source signal to ensure that it is properly
connected
The correct input source has not been selected Select the correct input source by pressing the Source key on the
remote.
Possible Causes Solution
The Projector is not in focus Adjust the focus with the focus adjustment dial until the image
comes into focus
The Projector is oset from plane / angle of
operation
Move the projector so that it is at both 180 degrees and on an
even plane with the screen. Please see Page 9
Possible Causes Solution
SD Card is not inserted properly Re-insert SD Card
SD Card is damaged Replace SD Card
THE PROJECTOR DOES NOT TURN ON
NO PICTURE
IMAGE IS BLURRED
SD CARD IS NOT RECOGNIZED
Possible Causes Solution
The remote control battery is dead Replace the battery with comparable CR2025 battery
REMOTE CONTROL DOES NOT WORK