User's Manual

30
Technical Details
Chapter 5
IMAGE IS BLURRED
Possible Causes Solution
The Projector is not in focus Adjust the focus with the focus adjustment dial
on the back of the BP1 until the image comes into
focus.
The Projector is offset from plane / angle of
operation
Move the projector so that it is on an even plane
with the screen.
NO SYNC, NO SIGNAL
Troubleshooting
1. Be sure to setup the computer to enable a video signal output. On some lap-
tops this is done by pressing and holding Function F5 key. If using the BP1 as
an external monitor on Windows based systems, this can be done by selecting
“extend my desktop to this monitor”. Depending on the video driver different
resolutions may need to be selected for proper output.
31