Use and Care Manual

10
Assembly
Middle &Upper Handle
1.Connect the lower handle and
middle handle with locking knobsand
bolts.( Fig. 3)
Fig.3
2.Connect the upper handle and
middle handle with locking knobs and
bolts.
3. Attach the cable-clamp to the
position shown and then attach the
cable. (Fig.4)
Fig.4
DirectionAdjustment Lever
1. Remove the screw from the upper
lever. Insert the lower lever intothe
upper lever, tighten themwiththe
screwremoved. (Fig.5)
Fig.5
2.Insert theleverbracket into the hole
on the upperhandle, tighten it with
flat washer, spring washer and
butterfly nut.(Fig.6)
Fig.6
3.Remove the cotter pin from the gear
lever. Insert the lower leverinto the
hole of thegear lever. Then secure itin
place withthe cotterpin. (Fig.7)
Fig.7
4. Check the discharge chuteby
turning it fully from left to right
(0~180°). The dischargechuteshould
rotate freely. (Fig.8)
Fig.8