21” DECK LAWN MOWER 2 0 C U T T I N G PAT H GAS POWERED AAVIX LAWN MOWERS OWNER’S MANUAL AGT1320 Read this manual carefully. Learn how to operate and maintain your product properly to avoid injury and product damage. You are responsible for operating the product properly & safely. WARNING: FOR SAFE OPERATION, READ OWNER’S MANUAL PRIOR TO USE.
AAVIX at 1-866-591-8921
• Do not operate this machine while under the influence of alcohol or drugs. Uneven terrain could cause a slip or fall resulting in severe injury. Poor footing could cause a slip or fall.
Product Specification Component Rated Power Rated Speed Displacement Cutting Width Height Adjustment Wheels Machine Weight 1. Remove the handle knobs from the mower housing. (Figure 2) Important: Route the cables to the outside of the handle as you install the handle. Specification 3600w/5HP 3000RPM 159cc 20” 1.75”-3.75” 7” Front 12” Rear 66.2 lbs Safety & Instruction Decals Important: Safety & instruction decals are located near areas of potential DANGER. Replace damaged decals. Figure 2 1.
Product Overview Figure 5 Figure 4 1. Air Filter 3. Oil Fill/ Dipstick 5. Handle Loosening Knob 2. Fuel Tank Cap 4. Height Adjustment Checking the Engine Oil Level Service Interval: Before each use or daily 1. Remove dipstick, wipe it clean, and fully install the dipstick. (Figure 6) Operation Attachments/Accessories A selection of AVVIX approved attachments and Accessories are available for use with the machine to Enhance and expand its capabilities.
Cutting Height Adjustment Adjusting the cutting height may bring you into contact with the moving blade, causing serious injury. • Stop the engine and wait for all the moving parts to stop. • Do not put your fingers under the housing when adjusting the cutting height. If the engine has been running, the muffler will be hot and can severely burn you. Keep away from the hot muffler. Adjust the cutting height as desired. Set all four wheels to the same height.
Mulching the Clippings • Alternate the mowing direction. This helps disperse the clippings over the lawn for even fertilization. • If the finished lawn is unsatisfactory, try one or more of the following. • Replace the blade or have it sharpened. • Walk at a slower pace while mowing. • Raise the cutting height on your mower. • Cut the grass more frequently. • Overlap cutting swaths instead of cutting a full swath with each pass.
Replacing the Air Filter 3. Tip the mower onto its side, with the dipstick down, to drain the used oil out through the oil fill tube. (Figure 15) Service Interval: Every 25 Hours 1. Use a screw driver to open the filter cover. (Figure 12) (Figure 15 (Figure 12) 4. Slowly pour oil into the oil deposit until the oil level reaches the full line on the dipstick. (Figure 15) Do not overfill. (Max 20oz. (0.59 L), type: SAE 30 detergent oil with an API service of SF, SG, SH, SJ, SL, or higher.) 2.
Storing/Unstoring 1. Loosen handle knobs 2. Move the handle forward as shown in Figure 18. Connect the wire to the spark plug.
Parts List
