AAVIX OUTDOORS 12AMP VARIABLE SPEED LEAF BLOWER FOR SERVICE CALL: (USA)1-866-591-8921/(CANADA)1-514-885-0916 WARNING : To reduce the risk of injury, user must read this manual before assembling, operating and maintaining this unit, You are responsible for operating the product properly & safely. Version: V1.
WARNING! READ ALL INSTRUCTIONS BEFORE OPERATING! Follow all instructions. Save all warnings and instructions for future reference. These instructions below are for your safety. Please read through them thoroughly before using. Familiarize yourself with them to reduce hazards like personal injuries and damage to property. TABLE OF CONTENTS Safety Rules.………………….……………………………………..…2 Symbols….……………….………………………………………….…4 Specifications..……….……………………………………….………..5 Know Your Leaf Blower……………………………….…………........
appliance. Receptacles are available having built-in GFCI protection and may be used for this measure of safety. 8) WARNING -To reduce the risk of electric shock, use only with an extension cord intended for outdoor use, such as an extension cord of cord type SW-a, SOW-a, STW-a, STOW-a, SJW-a, SJOW-a, SJTW-a, or SJTOW-a. 9) Extension Cord - Make sure your extension cord is in good condition. When using an extension cord, be sure to use one heavy enough to carry the current your product will draw.
(B) CONNECT PLUG AND RECEPTACLE • This blower is intended for residential use only. Commercial use of this product is prohibited and will void the manufacturer's warranty. • Never run the unit without the proper equipment attached. Always ensure the blower tubes are properly installed. Additional Safety Instructions Specific Safety Rules for Blower • Use extra care when cleaning on stairs. • Keep firm footing and maintain good balance at all times. Do not overreach.
Wear protective, slip-resistant footwear. Warning! Rotating impeller, keep fingers / hand away.. Double insulation Do not expose to rain at least 5m(16.4feet) from bystanders. ear long hair uncovered. Use a hair net. Remove plug from the mains immediately if the cable is damaged or cut Remove the power plug before maintenance and repair work. SPECIFICATIONS Model# A11802 Rated Voltage 120V~60Hz Rated Power 12Amp No-load Speed 8000 - 14000 min -1 Max. Air Speed 280km/h(174m/h) Weight 2.
ASSEMBLY WARNING!: ENSURE THE TOOL IS TURNED OFF AND DISCONNECTED FROM THE POWER SUPPLY BEFORE PERFORMING ANY OF THE FOLLOWING OPERATIONS. Assembling the Blower Tube 1. Insert the upper blower tube into the matching lower blower tube and push together until they are connected firmly. The cord retaining hook is used to “anchor” an extension lead (not included) when it is connected to the power cord of the tool.
NOTE: To use the shoulder strap simply slide the strap over your shoulder so that some of the weight of the blower can be taken by your shoulder. OPERATION CONTROLS WARNING! THE POWER SUPPLY FOR THIS PRODUCT SHOULD BE PROTECTED BY A RESIDUAL CURRENT DEVICE RATED AT 30mA OR LESS. NOTE: Must be fully assembled before use. On/Off Switch 1. To turn ON push the on/off switch right to the ON(I) position.
ON IN ENCLOSED OR POORLY VENTILATED SPACES OR IN THE PRESENCE OF FLAMMABLE AND/OR EXPLOSIVE LIQUIDS, GASES AND POWDERS. MAINTENANCE WARNING! ENSURE THE BLOWER IS DISCONNECTED FROM THE POWER SUPPLY BEFORE PERFORMING ANY OF THE FOLLOWING OPERATIONS. • There are no user serviceable parts in the blower; if a fault is suspected or the supply cord requires replacement, return the blower to a power tool repairer. • Keep air intake clean and air vents free from debris to avoid overheating the motor.
