Use and Care Manual

19
7. Wipe off any moisture with a soft
cloth.
8. Lightly coat the blade and all screws
with a corrosion-inhibiting oil.
Ventilation Motor Conducts
Eliminate any dirt in the ventilation
conducts so as notdamage the engine
and avoid the machine overheating and
even burning.
Checking After Each Use
1. Check for any loose, worn or
damaged parts.
2. Repair or replace damaged parts and
tighten loose screws, nuts or bolts as
necessary or contact an authorised
service centre for repair before using
the product again..
Checking The Power Cord
1. Never use the product with a
damaged cable or with the electric
power source damaged.
2. Before connecting the product.
Check the plug, power cord and
extension cord periodically for
damages. If you find any damages,
have it repaired before operating. If
the cable is damaged or broken,
disconnect the product immediately.
Damaged cables or twisted cables
increase the risk of electric shock.
3. Damaged cords should be replaced
or repaired by an authorized service
center.
\
Blade Maintenance
When checking the
blade,wait for a few
moments after switching
the product off, the blade will carry on
moving.
1. Keep the hedging blade clean and
free of debris. Remove trimmings.
2. Keep the hedging blade sharp to retain
a good cutting performance. Replace a
worn or damaged cutting blade with a
new one of the same type.
3. Lubricate the hedging blades
regularly with oil after each use to
prolong the life span of cutting blade
and product. Apply light machine oil
along the edge of the cutting blade.
4. The blades of this product are high
quality metal and do not need to be
filed. If accidentally, the blade
catches on a metallic surface,
touches a rock or any other hard
object, a small breakage could occur.
If this small breakage does not
impede the blades functioning
correctly, then you can carry on
using the product. If, on the other
hand, the product does not work
properly, then take the product to
customer service center.
5. Blade sharpening must be carried
out by the service dealer. Do not
sharpen the blade yourself. The
blade must be sharpened
guaranteeing the cutting angle and
blade equilibrium. Blade sharpening
carried out by a non expert will
result in the product vibrating and
will eventually cause damages to the
product and usage problems to the
end user.
STORAGE
1. Follow all aforementioned
maintenance instructions. Clean the
product as described above.
2. Storein a well-ventilated place that
is inaccessible to children.