Use and Care Manual

17
surface in a sweeping motion
following the shape of the hedge or
shrub. A slight tilt downwards of the
cutting blade in the direction of
motion is recommended for optimum
cutting performance.
21.Move the product with slow motion
forward when cutting higher hedge
and the cutting area out of sight.
22.Do not to rush and do not attempt
to cut too much with one stroke of
the cutting blade.
NOTE: Try to keep the cutting blade
angled at approximately 15° to the
cutting surface.
23.Cut in a number of stages if the area
being cut is particularly long to
achieve a better result; smaller
cuttings will allow for easy
composting.
NOTE: When shaping it is advisable
to achieve a trapezoidal shape. A
trapezoidal cut corresponds to the
natural growth of plants and results in
optimal hedge growth, as it will
expose more light to the bottom of
the hedge.
AFTER USE
1. Disconnect the product from power
source. Always allow the unit to cool
down before performing inspection,
maintenance and cleaning work!
2. Check, clean and store the product
as described below.
MAINTENANCE
WARNING:Before
inspecting, cleaning, or
servicing the machine,
disconnect the plug from
power source and wait for all moving
parts to stop. Failure to follow these
instructions can result in serious
personal injury or property damage.
NEVER perform maintenance or repairs
while the unit is running.
WARNING: When servicing,
use only identical replacement parts.
Use of any other parts may create a
hazard or cause product damage.
Do not modify the product or the