User's Guide

III Super16
- Remove the four screws which hold the CCD cover onlo the
battery s
id e of the camera. Carefu ll y remove Ihe CCD coyer.
-
Locate two allen head screws identified by a red dot. Looscn
the sc rews one tum.
- While looking
al the monitor, geplly move th e CCD head until
the view
in g screen image is in focu s. Notice th al thi s adj ustrnenl
also
affects image rotation. When sharp and even focus is
achieved and the image is square
tO th e monitor. tighten the I WO
screws.
_ Locale
th e i ri s rod on the CC D head and position il by hand 10
an uprig hl position. Replace the CCD cover on the body; takc
care to
locale th e iris control fo rk and position il around the iris
lever. Tightcn
th e four screws 10 secure the cover in place.
Operate the manual iris lever and check that the CCD iris itself is
func
ti oning by looklng al th e monitor. li the brightness of the
image does nol change. the iris rod may not
be engaged in the
control fork.
If this is th e case. remove the CC D cover and
repeal the procedure.