User's Guide
Step 6 - Realigning the CCD Assist Target
Th
e CCD assist needs
ID
be reposirioned
and
refocused ID be
properly aligned to the new optical center.
- Fasten the CCD assist to the camera body by means
of
three
allen screw
s.
Attach a monitor and BNC cable and power the
camera and assist.
If
the monitor has an underscan mode, select
it. Because
al!
other elements
of
the body have already been
converted, the CCD image should be soft and
off
to one
si
de.
- Locate the beamsplitter axis adjustment, which is to the aboye /
right
of
the aperture and consists
of
an allen screw within a slot.
Notice a red dot to the upper left
of
the slot indicating the posi-
tion
of
the screw for SuperI6. Loosen the allen screw 1 rum;
while looking at the monitor move the screw within the slot in
the approprate direction until the image
of
the screen is centered.
1 Standard
16
t moye
allen
screw
Down
t
Super16
moye
allen
screw Up
- The resulting CCD image, after this ad justm en t, should now be
centered but slightly
out
of
focu
s.
Follow the next few steps to
refocus the CCD head.
Super16
79