User's Guide

_~tDcllslnlhe.
!Ulaœoflhe"'-ing ...... _ ._
** ........... IrIP~1II
.. _ ......... _~ ..
...... 1IIe 1:IIiIIIICIIiIe_ ..... •
JOU do ... 11* CDIIIIderII~ III
SCIIII1InIlls 1dIion, .. __ _
d '--1!1IIII:tIm0ll1llt"lolloWl
....
62 Claanlng
3.2 Eyepiece
Clean the eye lens (A), whîch is the outennost element closest to
your eye, by flISt blowing the surface with canned air, then clean-
ing with lens fl uid and a Q-tip. Remove the eyepiece and clean
the field lens (B ), which is located on the inside of the eyepiece,
in the same fashion.
3.3 Viewfinder
With the cyepiece off, look into the remaining viewfinder and
clean the exposcd element of the pechan prism using canned air
or an air syringe. lf dirt particles are still present, remove the
viewfinder
assembly from the camera by removing the four aIlen
sc rews that hold the base of the viewflDder to the front housing.
C1can the exposed element of the viewfinder.
3.4 Vlewlng Screen I lnterior Surface
The las! surface to he cleaned aIso happens to be located in a
mes! de
li cate area. With the viewfinder off , look into the top
cavity of the camera body and visually locate the top interior sur-
face of the viewing sereen.
lfyou shoot with the CCD assist, you will also notice that the
retractable beamsplitter will most li kely he in place between your
eye and the viewing sereen. If this is the case, remove the bcam-
splilter access eap on the baltcr)' side of th e camera and retract
the beamsplitter by rotating th e adjustment screw approximate ly