User's Guide

341 The Camera Body
XTRplus aod providcs +1 -, and came ra on/ u ff . II is designed 10
accept a power zoom as its rrnUn input but will accept any acces-
sory which doe s not rcquirc: a sync signal. and providc rcmotc
on/off control
as well.
13.5 Lemo2 - OnJOff Input
Thc Lemo2 connector, located on Ùle battery side al the front of
the base, provides camera on/ o ff and is primarily used to carry
handgrip on/off functions to the camera body.
Th e Lemo2 can
al50 he used for remote on/off control.
13.6 Lemo5 - Tlmecode Input
The Lem05 conneetor, located on the mo l or side 10 the lower left
of the motor, is the timecode interface. Il is used when recording
AatonCode and provides
time c ud e communication in hoth
ASC O (in/out) and SMPTE (in).
The Aaron VR42 black & white and VR46 coIor CCD t ap-f are
desÎgned
to add vÎdeo assist capabîlity 10 the XTRpIus without
compromising rhe body's
size, jIexibilifY and euse-of-use.
Because the CCD
head is incorporuled inta the XTRpIus ca me ra
body, there are no centering or focus adjustments necessary
(Ul11ess, of course, when convertinglhe body between 16 and
Superl6formaI.f). The cOn/rol unitsf o rull AalOn CCD assists
attoch quickly to rhe camera's PBX housing and carl ~ used with
an on-board banery.
14.1 I nstalling the Control Units
The VR42 and VR46 control unilS can be easily attached onto th e
XTR.plus in a few sec ond s without the need for adjustment.
Remove the
two allen screws locatcd on the PBX immediately
hel
ow the LemoI4 connector. Mate the amph9 and Lemo14 con-
nectors of Ùle control unit to thosc connectors on the body and
plug in the unit.