User's Guide
32 The
camera
BOOy
Furthcrmorc, thc sizc
or
position
of
the film [oop does Do
t,
in
any
way, affect the accuracy
orthe
recorded timeeode.
AatonCodc
is
initia1izcd
in
the camera,
in
ASCO
or
SMPTE
form,
wough
the Lem05
conn~
t
or
located to the left
of
the
motof on the motor side
of
the body.
For
the most straightf
or
-
ward
Wld
reliable communication, OriginCplus, Aaton's master-
clnek. comparator, and SMPTE generator device, should be used.
For more elaborate information regarding the uses and function-
ing
of
AatonCode, OriginCplus and other relatcJ devicc:s, refer to
the AatonCode chapter
of
this handbook.
The following operator control/ed parameters can
be
manitored
by
the LeD display
of
the XTRplus. For more concise informa-
tion,
see the table in the
Sysum
Features
and
CQntrols chapter
of
this manual.
11 .1 AatonCode
If AaronCode
ha.<;
been initialized
in
the camera, the display will
indicate the running timecode any time the on/off
!\wi
tch
i.e;
in
the
otT
position. The
XTRplus
will allemately display hours/min-
utes, then minutes/eounting seconds.
11.2
ASA Setting
With the magazine
off
the camera, switch the camera onloff
!\witch
to
test position. The display will show the ISO setting
of
the
ASA knob.
11.3
Battery Voltage
With the magazine on
or
off
the camera. press button 3:
th
e dis-
play will read and indicate the voltage
of
the attachcd battery.
Notice that,
if
the
camera
is
running and button 3
is
pressed, the
display will indicate the voltage under Joad.