User's Guide

4.3 TRIPOD USE
In order to use the Xterà on a standard tripod, the tripod's quick
release plate must be fastened to the underside of the camera body
with its standard 3/8-16 screw. Make sure to use only a quick release
plate screw provided by the manufacturer; non-standard screws lon-
ger than 8mm (1/3") can fracture the base casting and damage the
camera's electronics.
4.4 SHOULDER OPERATION
One of the most attractive features of the Aaton system has always
been its comfort and ease of use in handheld situations.
The Aaton S16 camera line does not require the use of shoulder
braces or additional padding for handheld operation. The contour
of the camera and magazine is designed to fit snugly around the
operator's shoulder. The wooden handgrip is attached to the front
rod coupler at a slight angle to bring the operator's elbow into his
side and increase stability.
The system can be completely built off the 15mm front rods with-
out the use of a bridgeplate to allow for quick changing from shoul-
der to tripod operating modes.
4.5 CARRYING HANDLE
The carrying handle of the Xterà is reinforced to safely accommodate any carry-
ing, operating or mounting situation.
4.5.1 3/8 Accessory Screw
The handle features a 3/8-16 insert to receive accessories such as
french flags and lightweight monitors. Be sure not to use a 3/8
screw longer than 10mm (7/16"); longer screws can fracture the in-
60