Setup guide

Dial a pre-defined number by dialing one or two digits. Speed Dial 8 allows you to set up to eight
speed dial numbers that can be called with the push of a button. Enter the number as you would
normally dial it and then just hit that number on your touch pad to call it. You can also program
your speed dial using your phone and the star code for Speed Dial 8.
User Action required activating or using:
Pick up the receiver
Listen for dial tone
Press *74
Dial the single digit code under which the number is to be stored (2-9)
Dial the complete number to be stored just as if you were going to dial it yourself
Listen for Confirmation tone (two short beeps)
Hang up or repeat the sequence
Note: To enter IP addresses, a graphical user interface like a web browser must be used.
Expected Call and Network Behavior:
Pick up the receiver
Listen for dial tone
Press single digit code assigned to the stored number (2-9)
Press # to signal dialing complete
The number is automatically dialed normally.
Call Waiting (Per Call)
Answer a call while already on another call. Call Waiting allows you to receive another call while
you are on the phone. When a second call is received while you are already on the phone a call
waiting tone alert you. See the callers ID on your phone if you are using Caller ID. To answer the
waiting call, simply press the flash button or switch hook. You will be connected with the waiting
party and while your original party holds. Press the flash button or switch hook again, to
reconnect to the original party and hold the waiting party. You can continue to alternate between
parties as often as you’d like. It’s like having two lines while paying for only one.
The user can also cancel Call Waiting for calls in progress. Simply dial the *70. Feature access
code directly from your phone. The system plays a confirmation announcement and then applies
a dial tone. The user then dials the destination number. For the duration of the call, the user is not
presented with any waiting calls. Call Waiting is automatically re-activated when the call ends.
Call Waiting completes when any party hangs up. Users can also execute call waiting via the
VoIP Service Call Manager.
*70 – Deactivate
*71 – Activate
Distinctive Ring/Call Waiting
Allows the subscriber to have incoming calls from a limited number of calling parties identified by
using the distinctive alerting treatment on your while you are on your VoIP Service.
*61 - Activation