Setup guide

• Wait 10 seconds, and then plug the power back into the Adapter.
• Repeat the steps from the beginning above.
DSL/PPPoE Set Up for Sipura
The following set up information works for Sipura 2100 Internet Access Device. If you have
another brand of IAD, you can try to follow the same steps. If it doesn't work, please contact
us.
BEFORE YOU BEGIN:
These steps are only needed if your DSL connection requires a User Login and Password
entry in order to connect to your DSL service. If so, you must have both your User Login
and Password in order to complete these steps. For additional information regarding your
User Login and Password, please contact your DSL service provider prior to beginning
these steps.
NOTE: The easiest way to start is by connecting a PC directly to your DSL modem and
logging into the World Wide Web as you would normally do. The Sipura 2100 will allow you
to share your Internet network for both VoIP Service and your PC. You can connect the
Sipura 2100 and move your PC to the PC port of the Sipura 2100 after the first few steps
below (see Figure 2 for multiple computer installation with a router/hub
).
Prior to installing your Sipura 2100, connect your PC directly to your DSL modem and log
into the World Wide Web as you would normally do. You will connect your PC to the Sipura
2100 only after your PPPoE network connection information is entered into the Sipura
Service Portal. Click here
to learn how.
Setup your network according to the Figure1 below. Be sure to connect your PC via an
Ethernet cable to the LAN port of the Sipura 2100.