Setup guide

Sipura devices: SPA1000, SPA1001, SPA2000, SPA3000
In order to upgrade your Sipura phone adapter please follow these instructions:
• Confirm that the power is plugged into the adapter and delivering power.
• Be prepared to write down an IP address:
o Pick up phone and dial * * * * 1 1 0 # to get the current DHCP provided IP address of the
adapter on your network. Take a note of it, including the dots.
o Open your browser (ie: Internet Explorer) and type the IP address that you heard in the
address bar (ie: 192.168.0.1).
o The Sipura configuration page will open. Click on the admin and then on advanced.
These links are in the upright hand corner of the initial page.
o Click on the Provisioning tab.
o In the Profile Rule field, hi-light and delete any of its contents.
o Hi-light, copy and paste the following string into the now empty Profile Rule field:
http://spa.myipservice.com/spa$MAU.bin
o Scroll to the bottom of the page and click on Submit all Changes.
The screen will turn white with a short message stating: SPA is updating your
configuration. Unit may reset. Sipura configuration page will return in 5 seconds.
o If the page returns with a request for a User Login and Password, simply click Cancel
and return to the Sipura configuration page browser.
o Power cycle your Sipura adapter by pulling out the power cord, waiting 10 seconds, and
replacing the power cord.
The status light on your Sipura adapter will blink for approximately 15 seconds, please do
not interrupt this process by picking up you telephone handset.
When the status light has halted all blinking your adapter should now be fully configured
and your phone should now have a dial tone.
If the Sipura Web Configuration page does not return to your browser after clicking
the Submit All Changes button
If the Sipura Web Configuration page does not return to your browser after clicking the
Submit All Changes button:
• Unplug the power to the VoIP Service Router and Phone Adapter.