User guide

Enhanced Feature Adapter User Guide 19
Regulator y infor mation
Canadian regulatory
information
Industry Canada Notice
The Industry Canada label identifies certified
equipment. This certification means that the
equipment meets certain telecommunications
network protective, operational and safety
requirements. The Department does not
guarantee the equipment will operate to the
user’s satisfaction.
Before installing this equipment, users should
ensure that it is permissible to be connected to
the facilities of the local telecommunications
company. The equipment must also be
installed using an acceptable method of
connection. The method of connection
approved for this equipment as designated by
D.O.C. Standard CS-03 is a CA11A/CA14A
or CA11W/CA14W connection arrangement.
The A or W suffix indicates that either desk or
wall mounting is approved. In some cases, the
company’s inside wiring associated with a
single line individual service may be extended
by means of a certified jack-plug-cord
ensemble (telephone extension cord). The
customer should be aware that compliance
with the above conditions may not prevent
degradation of service in some situations.
Existing telecommunications company
requirements do not permit their equipment to
be connected to customer provided jacks
except where specified by individual
telecommunications company tariffs.
Repairs to certified equipment should be made
by an authorized Canadian maintenance
facility designated by the supplier. Any repairs
or alterations made by the user to this
equipment, or equipment malfunctions, may
give the telecommunications company cause
to request the user to disconnect the
equipment.
Users should ensure for their own protection
that the electrical ground connections of the
power utility, telephone lines and internal
metallic water pipe system, if present, are
connected together.
This precaution may be particularly important
in rural areas.
CAUTION : Users should not attempt to make
electrical ground connections themselves, but
should contact the appropriate electric
inspection authority, or electrician, as
appropriate.
NOTICE : The Load Number (LN) assigned to
each terminal device denotes the percentage of
the total load to be connected to a telephone
loop which is used by the device, to prevent
overloading. The termination of a loop may
consist of any combination of devices subject
only to the requirement that the sum of the LN
of all the devices does not exceed 100.
This telephone has been tested and found to
comply with the limits for a Class B digital
device in accordance with the Canadian EMI
requirement ICES-003.
CAUTION : To eliminate the possibility of
accidental damage to cords, plugs, jacks and
the telephone, do not use sharp instruments
during the assembly procedures.
WARNING : Do not insert the plug at the
free end of the receiver cord directly into a
wall or baseboard jack. Such misuse can result
in unsafe sound levels.
This symbol on the product is also used to
identify the following important information:
Shock Hazard Warning:
To avoid potential electrical shock hazard to
personnel or damage to the telephone, use only
the manufacturer supplied equipment and
installation procedures. Specifically, use only
6 conductor modular Teladapt plug/cords with
The exclamation point within
an equilateral triangle is
intended to alert the user to the
presence of important operat-
ing and maintenance (serving)
instruction in the literature
accompanying the product.