User guide

Enhanced Feature Adapter User Guide 7
Installing and using the
Adding the Venture Door
Phone
Adding the Venture Door Phone
(Aastra part number: A0665958)
enables you to answer a door from
one or all the phones in your Venture
system.
☞
Note: Only the Venture Door
Phone can be used with your EFA.
Connecting your Venture Door
Phone
You will need a pair of 16 to 20
gauge solid wires such as telephone
wire or doorbell wire. These are
available at most hardware and
building supply stores.
1. Follow the instructions included
in your Venture Door phone for
connecting the wires to it.
2. Strip approximately 1/4 inch of
insulation from the other end of
the wires.
3. If the wires are stranded, apply
solder to the wires to make them
solid enough to insert into the
EFA terminals.
4. Insert the wires into the two
terminals. It does not matter
which wire goes into which
terminal.
☞
Note: To disconnect the
door phone wires from the EFA,
insert a stiff piece of wire (such
as a paper clip) into the slot
above the wire while pulling the
wire out of the terminal.
Activating your Venture Door
Phone
1. Go to any Venture phone.
2. Press £ .
3. Press ’ until your display
shows .
4. Press — .
5. Press ’ until your display
shows .
6. Press
¥
to turn on door phone
answering capabilities.
Setting Door phone options
By setting the following options, you
can customize the way your door
phone works.
—changes the
door phone name to any 16-character
name you choose.
—changes 98, the ID
assigned to your door phone at the
factory, to any 2-digit number you
choose.
—sets the number of
times a phone will ring when the door
phone button is pressed. (The default
is three rings.)
—sets door phone calls to ring
at all phones or one phone in your