Desk PDM Charger Installation and Operation Manual 20/1531-ANF 901 43 Rev C 2011-11-24
Installation and Operation Manual Desk PDM Charger Copyright © Copyright Aastra Technologies Limited, 2011. All rights reserved. Disclaimer No part of this material may be reproduced in any form without the written permission of the copyright owner. The contents of this document are subject to revision without notice due to continued progress in methodology, design and manufacturing. Aastra shall have no liability for any error or damage of any kind resulting from the use of this document.
Installation and Operation Manual Desk PDM Charger Contents 1 Introduction ........................................................................................................................... 2 1.1 Abbreviations and Glossary ............................................................................................3 1.2 Safety ..............................................................................................................................3 1.3 Technical Solution .......................
Installation and Operation Manual Desk PDM Charger 1 Introduction This document describes how to install, configure and operate the Desk PDM charger. The Desk PDM Charger is an advanced charger equipped with a USB port, making it possible to connect it directly to a PC for the purpose of upgrading or configuring the Desk PDM Charger itself or a handset placed in the charger. The Desk PDM Charger also has two Ethernet ports, enabling upgrading and configuring over a LAN of a portable placed in the charger.
Installation and Operation Manual Desk PDM Charger 1.1 1.2 Abbreviations and Glossary device In this document, a device can be Desk PDM charger or a handset developed to work together with Desk PDM Charger and WinPDM/CPDM3. See respective manual for each device. DHCP Dynamic Host Configuration Protocol, protocol for automating the configuration of computers that use TCP/IP Easy replacement A handset replacement procedure that is done via the handset display and does not involve the WinPDM/CPDM3.
Installation and Operation Manual Desk PDM Charger 2 Installation and Configuration 2.1 Desk PDM Charger Installation The chargers shall be placed in a dry environment with a temperature range from 5° C up to + 40° C. Delivery includes: • • • • Desk PDM Charger Power Supply Cable (AC cord with corresponding wall plug) Power Supply adapter including DC cable USB cable No tools are required. Figure 2. 003 USB Figure 2. Desk PDM Charger connections.
Installation and Operation Manual Desk PDM Charger 2.1.1 Software installation The charger is delivered with pre-installed software and it is possible to upgrade the charger software. See Installation and Operation Manual for WinPDM, or Installation and Operation Manual for CPDM3 for instructions on how to upgrade the charger. 2.2 Desk PDM Charger Configuration Each Desk PDM Charger need access to DHCP to receive an IP address automatically.
Installation and Operation Manual Desk PDM Charger 2.3 Security (information regarding software security) N/A 3 Commissioning Follow these instructions to verify that the charging works. 1 Connect the charger according to chapter 2.1 Desk PDM Charger Installation on page 4. 2 Place a handset in the charging slot to start charging. The handset indicates the charging progress, see respective manual for details. See figure 2 on page 4 to see the connections to the charger.
Installation and Operation Manual Desk PDM Charger 4 Maintenance 4.1 Operation when charger is connected to WinPDM/CPDM3 When the charger is connected to a WinPDM/CPDM3, the following additional operations can be done: • Software upgrade (of charger or handset) • Parameter editing (of charger or handset) • Phonebook upload (handset) • Language upload (handset) See Installation and Operation Manual for WinPDM, or Installation and Operation Manual for CPDM3 for details. 4.
Installation and Operation Manual Desk PDM Charger 4.4 LED indications Desk PDM Charger is equipped with a status LED. The following indications are used: LED indication Description None Not connected to power. Green, fixed Logged on to WinPDM/CPDM3. Orange, fixed Not logged on to WinPDM/CPDM3. Orange, flashing (1000 ms on, 1000 ms off) 1) Software download. 2) File transfer during Easy Replacement. Orange, flashing (100 ms on, 800 ms off) “Change phone” indication during Easy Replacement.
Installation and Operation Manual Desk PDM Charger 6 Troubleshooting For general LED indications, see also 5 Operation on page 8. Status LED on the charger is not lit. Check that power is supplied. If power is supplied and the status LED is still not lit: The probable cause is a software error. Send charger for service. Status LED on the charger is fixed red. Software error. Send charger for service. Status LED is flashing red for 3s, then green Software error. A factory reset has been performed.
